The register is always an instruction pointer, even if the hardware incorrectly calls it a program counter.
The processor that matters most, by far, is x86. At one point PowerPC wasn't too far behind, and PowerPC still dominates in high-end network gear. Both of these processors are correctly documented. For x86 the name is ip, eip, or rip. For PowerPC the name is usually nip, meaning "next instruction pointer". Sometimes the PowerPC documentation will use "current" instead of "next", or "address" instead of "pointer". All of these are correct.
Also, in electrical engineering, the direction of electricity is taught backwards from what it really does. In all sources I've read, electricity flows from positive to ground, whereas in reality, it's the opposite. Good luck in changing that.
[1] Technically, until you get to the 64-bit version, it's `CS:IP` (Code Segment, Instruction Pointer).