Re:Openwrt 18.06.2 released
by johnt15 on Saturday February 02, 2019 @01:08PM
(#19064546)
Are there any routers supported by OpenWrt that can handle 1Gbps WAN to LAN? My current router only pulls 150Mbps and I want to keep OpenWrt due to the amount of custom network configuration that has been done.
[ Parent
| on HN ]
EdgeRouter gets pretty close running OpenWrt. And hits your mark if you keep the stock firmware. No wifi though.
https://an.undulating.space/post/180927-er_alternate_firmwar...
Maybe the Turris Omnia if you need WiFi and aren't worried about cost: https://omnia.turris.cz/en/
The NetGear R7800 would be somewhere between the two in cost, and reportedly does GB for wired, somewhat less over WiFi. Pretty easy to find used ones for $100USD too.
Looks like EdgeRouter X fits my requirements and is pretty cheap (50Eur). Thank you!
Re:Openwrt 18.06.2 released
by theandrewbailey on Saturday February 02, 2019 @09:22PM
(#19067384)
Try looking at the fast path module.[0] Your router might have some kind of Qualcomm NAT accelerator chip[1] that isn't natively supported/distributed by OpenWRT.[2] You'll have to compile your own build of OpenWRT, so it might be a bit difficult to get going. I haven't needed to do it, because my WAN connection is only 50 Mbps.
[0] https://github.com/gwlim/openwrt-sfe-flowoffload
[1] https://forum.openwrt.org/t/qualcomm-fast-path-for-lede/4582
[2] like mine https://openwrt.org/toh/wd/n750
Re:Openwrt 18.06.2 released
by bubblethink on Saturday February 02, 2019 @01:32PM
(#19064704)
What custom config ? If you need sqm with gigabit, x86 would be a safe bet. If you want just raw throughput without additional processing, others will do that fine.
WRT3200acm Or build a x86 box.
Re:Openwrt 18.06.2 released
by paulcarroty on Saturday February 02, 2019 @03:46PM
(#19065610)
Check Netgear devices.