News for hackers. Stuff that matters.
Re:MIPS Goes Open Source by amluto on Monday December 17, 2018 @08:03PM (#18703720)
> Branch delay slots are no big deal once you know they're there.

I disagree. I'm not really a MIPS user, but I've managed to encounter some branch delay slot issues, and, as an x86 system programmer, I can only imagine how unpleasant they must be. Here are some reasons:

- The program counter does not adequately describe the execution state of the CPU. In other words, starting or resuming execution with a given set of register values and a given address will do the wrong thing if you're resuming in a branch delay slot.

- Handling a fault due to an instruction in a branch delay slot seems highly problematic. Suppose you have a load in a delay slot and the load touches swapped-out memory. How is the operating system supposed to page in that memory and resume?

- Linux, and probably other operating systems, will emulate FPU instructions if the CPU doesn't support them. Emulating FPU branch instructions is deeply problematic because of delay slots.

Re:MIPS Goes Open Source by monocasa on Monday December 17, 2018 @08:55PM (#18703948)
The first two just mean that there's an extra trap state bit in a flags register for "I'm in a bench delay slot currently" and isn't really a big deal.

The third one I imagine is a pain in the ass, but I've been lucky enough to always compile MIPS for the exact CPU I was running it on.

Re:MIPS Goes Open Source by amluto on Monday December 17, 2018 @09:04PM (#18703982)
It’s more than just a bit. You need a bit saying “in a delay slot” and a whole word that stores the target of the branch.
Re:MIPS Goes Open Source by monocasa on Monday December 17, 2018 @09:25PM (#18704076)
Nah, a delay slot bit is fine. Branches haven't really retired yet (that's the point of a delay slot), so when you reenter the instruction with that bit set the CPU just backs PC up and executes both of them again.

You have to make sure you can map two pages at once in case the branch/delay pair straddles a TLB boundary, but you have to screw up pretty bad to not allow that.

Re:MIPS Goes Open Source by amluto on Monday December 17, 2018 @09:57PM (#18704214)
shudder

If you try this on hardware that also supports software single stepping (which x86 does, but MIPS seems not to by default), then you have to be extra creative to guarantee forward progress. The same issue arises if you have data breakpoints. And if the branch loads from MMIO space, you have a problem.

Re:MIPS Goes Open Source by monocasa on Monday December 17, 2018 @10:02PM (#18704237)
I mean, it's MIPS so it's a load/store architecture anyway. Between the pair you're only going to have one memory reference at most, and it's going to be the delay slot.