I don't have the equipment for this, but it might not be needed. The disc has writing that goes "through" the top cover, such that you can read the text by holding the disc up to a normal lightbulb.
The text is across the entire diameter and I don't know why it would cause problems for only this track. Possibly the shape of the text?
edit: photo https://i.imgur.com/fdtAAPG.jpg
Re:Why I Ripped the Same CD 300 Times
by userbinator on Tuesday July 31, 2018 @12:09AM
(#17650480)
That could be an area with insufficient contrast, a similar problem that early drives had when CD-Rs started appearing. In that case I would've tried a mirror or black pad (about the only thing those audiophile "disc mats" are good for...) on the top, to shift the offset level.
Note that CD uses 780nm infrared so what the human eye sees is not necessarily what the drive sees --- this is why "transparent" or "black" CDs work.
This didn’t seem to be an issue of wear or damage – the CD itself was probably defective from the factory.
It would be very interesting to look at the surface of the disc under a microscope, to see if you can find the defective area --- knowing which track it's in, you can determine the approximate diameter at which it occurs, and then rotate around that diameter looking for abnormalities. The pits and lands are invisible to the naked eye but easily viewable with a light microscope:
https://en.wikipedia.org/wiki/File:CD_Pits_at_6.25x_Magnific...
At 1200 bits/mm linear density of a CD, the 5KB (40Kbit) defective section will correspond to ~33mm of track --- probably quite obvious if it is a physical defect. (A "logical" defect, where the bits are OK but the ECC is wrong, will not be apparent at the physical level.)