A VAX 11/780 (size of a refrigerator) had more CPU power, but access was via RS232 link to a VT100 terminal. These could be pretty slow: it wasn't unusual to type a command line and wait up to 10 seconds (or a minute, in really bad times) to get a response. And a graph could easily take a minute to fully display on a VT240 graphics terminal.
A PC on the other hand had "user interface MIPs" and could display a graph instantly. What the PC couldn't do is run our very large, 32-bit required simulation code.
(As far as how easy it was to add a hard drive: at the time, to add a new disk to a sun station, you had to recompile the kernel)
And Vt240 was very much noddy graphics high end then was insanely expensive vector systems from HP os Tectronix
In 1982 Byte magazine had 420,000 subscribers. They might not have been the sort who bought from you and your store.
There were about 8M computers sold, and assuming Byte continued to sell at around 400K copies, this mean that there were 5% subscribers to every PC bought, or 1 out of 20. My guess is that sounds approximately correct for my hit rate. There were more pubs, but I bet that there were a lot of overlap for magazine subscriptions. If you subscribed to Byte, you probably had a good hit rate for also being a subscriber to PC Mag, so the spread probably wasn't a ton wider.
What I do remember was that Consumer Reports came out with a recommended PC. They loved the Leading Edge. Consumer Reports was a bit of cult back then and I bet their subscription base was in the millions (where does one find the subscribers for magazines in 1985?). When Consumer Reports suggested something, the word got around.
I remember people coming in asking for LE, but Ballard Computer had the franchise and was back ordered like 3 months.
Now that was power to influence the end buyer.
Well, that's deceptive. How many of those computers were purchased by a buyer for a business? (again, a population of buyers you might have had little or no exposure to) The ratio of subscribers to PCs purchased would certainly be higher.
It's not like there's anything hugely wrong with anything you're saying, but I was a kid who read Byte magazine and discussed benchmarking with adults, and I don't think we were all total freaks of nature or something. (that said, a benchmark measuring the execution time of a specific operation definitely represents the far side of wonkiness)
2. By the way, my 5% estimate on Byte saturation for my buyers is probably is too high. Refresh cycles were about 3 years back then, and there were roughly 11M PC bought in 1983 and 1984. There was around 8M PCs bought in 1985. So around 19M users of which 8M were buyers in 1985, which is where Byte was selling around 400K subscriptions. Therefore, the saturation rate of Byte magazine to PC users was roughly 400K/19M = 2.1%.
3. I loved your line "but I was a kid who read Byte magazine and discussed benchmarking with adults, and I don't think we were all total freaks of nature or something." Actually a young kid reading Byte magazine to discuss benchmarks with adults was a freak at the time.
I should know because I was one, probably the same as you.
Which store? I'm wondering if my first PC may have come from you. :) I remember it was a place in Georgetown, a 386 that came with DR DOS.
We sold IBM and Compaq gray market. We tried to go legit with Acorn (GEM) and Multitech, which turned into Acer. However, as I understand it, the owner was selling so much gray IBM offered him a dealership after I left.
I got my EE degree, already had a degree in accounting and finance, and eventually went to work for the IBM PC company, which was very strange considering I started off selling them gray market.
I started before the 386 and the PS-2, so I was probably back in school when you were buying.
Relative to today, it was non-trivial though physical access tended to be easier. http://www.oldskool.org/guides/tvdog/1kfaq.html#II.D.1
Also, the Tandy 1000 is bad example there because they were notorious for weird hardware incompatibilities and funky proprietary parts.
I can still hear the sounds that disk made (sort of like a spray paint can being shook) when it was seeking and the “clunk!” it made when you ran the park command.
In the mid 90's I rescued a PS2 8580 with a huge 20MB disk that sounded like a washing machine...$8500 brand new. Loved the Model M keyboard -- though didn't know what it was at the time -- and kept it well into the 00's.
The original IBM PC had a 63 watt power supply (I hope I'm remembering correct), so you had to take this out and put in a bigger one, but this was simple. Then you open up your hard drive box and put the paddle card in the slot and screwed in the HDD in one of the bays.
You need to know a few CLI commands like fdisk and format c: /s/v, and you had a c: prompt. The problem is that there was no youtube or internet. If you didn't know the few steps, this might as well have been black magic. (Even though most HDD kits did come with some instructions.)
The Quantum guys (a company I later worked for) came up with a novel idea of putting a hard drive on a card, and you could just plug in the card and that was it. This was the peak of simplicity, but carried a premium, so it was a niche product.
By the way, what most people don't realize is that the 3.5" form factor was actually the first portable hard drive. It was designed by Conner for the Compaq portable. Bill Frank was the technology guru at Western Digital, then a silicon maker, that lead the creation of IDE for Conner, the forerunner of SATA.
So it was tricky because of the lack of knowledge, but the actual work was pretty simple.
On the other hand, back then building a PC was probably easier because there were far fewer choices...thanks to a combinatorial explosion of CPU sockets, RAM specifications, MB form factors and such today. And anyone building a PC probably knew someone who had built one, if only the computer store owner.
The analogy I'd use is that it was simple back then to the degree Linux is simple today: reasonably logical and well documented. But Arch ain't iOS.
I had a "computer module" for the Intellivision game console, with a similar keyboard. It was bad for that, and I barely used the thing it was so useless.
IBM really ought to have offered a normal keyboard option, with the chiclet as a deeply-cut-price accessory "for the kids to use for games".
Generally, in the mid 80s, you needed base performance (8088/8086) or "3 times as fast" performance (80286) when the AT came about. Compaq (now HP) became the real competitor to IBM PC/XT because the end user could understand that they ran at 8 MHz vs the PC 4.77 Mhz. This is as much performance issues that the users would want to know. Better performance without needing to buy an AT. Then the clones came about, and everybody started to put a "turbo" button on front of the clone PC.
My first degree was in finance and accounting, but I fell in love with technology, so I sold PCs out of the biggest gray marketer in Seattle when the PC AT (second real computer for business) was coming out. I have first hand knowledge of the buying behavior because I was on the front lines of computer sales, and made a ton of good money selling $2-5K computers to people walking in off the street.
The advent of the PC revolution was all about apps. I'm not saying that there weren't benchmarks, and maybe you'd find a savvy buyer that subscribed to Byte magazine, but these were far and few between. Tandy simply didn't have Lotus 1-2-3. The PC Junior wasn't a performance issue, but the term "Junior" just killed the thing out of the gate. The investment in a PC was a lot of money, and you weren't going to get a Junior, you were going to get a real PC. (For instance, the keyboard was much more impactful than any performance thoughts.)
Finally, for those not around, storage was an incredible change agent. A lot of people think an SSD in a client platform is pretty cool. However, you cannot image the step up that a hard drive provided versus a floppy drive. The PC Junior and Tandy had no real hard drive path. While IBM had hard drive specific model (XT), the effort to install a hard drive in a PC was pretty small because of the accessibility. An open architecture, which any home builder takes for granted today, was pretty revolutionary at the time, and IBM's willingness to allow plug-ins (where they followed Woz) caused it to cremate the competition with a peripheral market.