On the other hand, I designed a STM32F4 based design last year and it was glorious. SnapEda for all symbols/footprints, Altium design vault for a specialized FPGA design, and github for a STM32 reference design PCB file using the same layers/copper weights as my requirements with imported fab design rules for good measure. The PCBs cost like $1500 and assembly was only $1600. 10 years ago I used to pay that much per single board in quantities of 30, for roughly the same complexity. This time, the whole thing (minus firmware) took a weekend.
Good luck with your mfg! If you have a chance, please blog about your experiences. There arent enough people spreading the art of solder.
It seemed like it wasn't I need fancy gear to make blinky lights, but rather for anything better than 8-bit, kilobyte, and low MHz, the only parts available was the fancy commercial stuff.
I do occasionally do small (100+ pins) BGAs - for that I get a steel solder stencil made and use solder paste and a cheap Chinese reflow oven
Once you see how easy it is to reflow a board you won't want to bother with hand soldering DIP packages anyway.
On the high speed digital front we do have 1Ghz DDR3 and its worked very well - we don't even use controlled impedance. Of course we are extremely careful to keep traces short and length matched. Our application can handle a very small error rate, however in practice we haven't seen any corruption at all in testing.
Its not the right approach if you are pushing the envelope of technology. But if you need a bit more grunt than an atmega by all means design in the ARM SoC and DDR3. You don't need fancy gear to do it.
Edit: Also thanks, we're looking into expanding more manufacturing in house and you've given me some ideas. I'll definitely look into an XRay machine.