News for hackers. Stuff that matters.
Re:Darpa invests $100M in a silicon compiler by jacquesm on Friday June 29, 2018 @07:29PM (#17428653)
Your comment reads as if you equate 'BGA' with 'SMD', a BGA is a ball grid array with up to 1,000 tiny pads that have been pre-dipped in solder. Your toaster isn't going to work.
Re:Darpa invests $100M in a silicon compiler by hak8or on Friday June 29, 2018 @07:58PM (#17428749)
Yes, it will. Sure, it won't do wonders with 0.5mm pitch bga's, but 217 pin 0.8mm ones are doable even with a cheap Chinese hot air station. That's how I did these boards.

https://brainyv2.hak8or.com/

Re:Darpa invests $100M in a silicon compiler by extrapickles on Friday June 29, 2018 @07:38PM (#17428682)
You can use a toaster, but your yield will be poor. Slapping some insulation on the oven and a PID controller will improve things significantly.

If you screw up the solder job, you can use a hot air gun to remove the BGA part, reball it (using a stencil, fairly cheap if its a common package), then try reflowing again.

If you practice for a few hours on scrap electronics, you can get good enough at it.

Re:Darpa invests $100M in a silicon compiler by slededit on Friday June 29, 2018 @07:55PM (#17428735)
BGA is actually easier than leaded SMD parts. The tiny leads tend to bridge easily. With BGA you can be up to half the pitch off and it will center itself. I actually only go for leadless and BGA now because anything else is more of a hassle.

It is a bit rude to assume I don't know what a BGA part is.

Re:Darpa invests $100M in a silicon compiler by jacquesm on Saturday June 30, 2018 @02:24AM (#17429741)
The tweezers bit is what triggered that. Handling a large BGA with tweezers is going to scratch the PCB if you're not ultra careful.

Anyway, if you do this stuff often enough then I see no reason why you wouldn't get the proper tools, a rework station and an actual reflow oven or something with a PID controlled heating element would make your life so much easier. Working with bad tools would drive me nuts.

The reason the larger BGA center themselves is as soon as the solder goes fluid there is a lot of accumulated surface tension trying to reduce the size of the bridge and that will center the part all by itself. For that to work properly though everything has to become fluid more or less at once and stay fluid until the part has shifted to the right position.

Re:Darpa invests $100M in a silicon compiler by slededit on Saturday June 30, 2018 @04:34AM (#17430018)
The tweezers are for the 0802 passives and nudging the FPGA itself. It takes forever but then so does programming the pick and place for a one-off.

As for the reflow you can actually get more consistent results with the toaster oven - It just won't be able to handle the volume of actual production. Whatever you do just don't try going "semi-pro" and getting one of those IR ovens from China. Stick with the $40 walmart special. The toaster oven when heated slowly is much less likely to have hot and cold spots. Stenciling and placing parts take up a lot more time and are much more error prone.