Not really. More likely just desoldering a couple of key components and soldering in a few wires to a dsughterboard with a linear regulator.

A year’s worth of power supply design? Have you looked at the LM7805 datasheet? The circuit is one regulator and two capacitors...

Have you looked at the current requirements for CPUs and GPUs? We're talking 100A or more. Even if the input was 3.3V, which it isn't, a linear regulator down to 1.1V would have to dissipate 220W or more. You'll need a bigger heatsink for the linear regulator than for the CPU...

And designing a 250W-capable linear regulator is not as simple as just hooking up a LM7805.

So with a modern CPU and GPU, your talking ~400W of power to the actual components, and nearly 500W wasted in the linear regulators. This of course also means you have to get a 1000W PSU as a bare minimum.

Here's the problem: not only do you have to dissipate 200W+ for your pass element, you need to drive it ultra fast with an extremely fast analog circuit that can withstand the massive magnetic fields (which pretty much means you need a PCB).

Yeah and good luck driving a 200W linear element (if it even exists, lol) with a few op amps--the driver which should deliver a few amps into the gate/base of the pass element, which in and of itself is a pretty difficult challenge.

old thread but

LMFAO you can't be any more wrong. You need /much/ more careful design to get GPU-compliant performance. The dI/dt on modern ASICs are insane, and you need an insane regulator to deal with it.