Unfortunately, this is true for at least one major ISP in the USA. IPv6 support is seen as a low priority internally, as they work to merely keep their devices online.
One huge secret about Juniper devices is that the hardware is remarkably unreliable. At one company, a partial Juniper SSG failure prevented a failover to good hardware. At another, we so many Juniper SRX RMAs that we had a full time network engineer handling the RMA paperwork. (Admittedly, they said we were their biggest client, and had a bigger implementation than Juniper's own network lab.) They have a bad habit of failing on reboot - one was operating fine, we reboot it and it reports errors. This happened repeatedly in several data centers - at one point we had 1/6 of our data centers non-redundant while we waited for RMA shipping.
This is patently untrue. The MTTF is the same as Cisco gear. The only reason this would be a "huge secret" is because it is not widely held opinion.
There are bad revision of chipsets on certain boards from time to time yes. And if you place a large order you will likely feel that pain if you're shipped boards with those revs. I know this first hand and with SRXs. Firewalls are but one segment of their product line and the one that was never their core strength(in fact this was the Netscreen acquisition.)
The T4000 and MX 960s are both "big iron" and in both the core and edge of Tier 1 ISPs. The reputation of these are exceptional and for good reason. Their EX/QFX ToR switches also have a well-deserved reputation.
To use your anecdotal experience with on particular segment of their product line and make a sweeping generalization of the quality of their entire offering is absurd.
I say this as someone who doesn't have a horse in the race and has very little love for network hardware vendors in general.
Juniper even instructed us to reboot the passive node before any failover, just to catch these issues.
You'd end up needing a much smaller array for v6 -- small enough that you could fit it into the presumably-unused parts of those 2^32 arrays that correspond to the v4 class E space.
Where is this? What do you have to back up this claim?
>how does that work when a customer's IPv4 address changes?
As far as I can tell, it wouldn't. But I don't see what your point is.
I'm not in Australia, but I've had the same IP for decades, even having gone through multiple routers, so it's probably tied to the DSLAM port I'm connected to, which makes sense for such a billing scheme. Also might be why I don't have IPv6 yet either.
If the rest of your message is true, why are the ipv6 numbers so low, if it's not because of politics?
I personally expected IPv6 growth to slow down gradually. I find it very odd that the growth hit a wall like that. Oversimplifying somewhat: The number of new v6-capable users increased every month, then boom, zero.
I also find it odd that politics would have no effect at 13% or 14% deployment and then block growth entirely at 15%.
In this context it has to mean something that didn't impede IPv6 growth at all for a while, then suddenly blocked IPv6 growth completely. Can't imagine what it would be.
(Sorry, didn't notice the comment until much too long had passed. I realise noone's going to read this. Oh well.)
Are you saying there are network engineers/management at ISPs who don't believe IPv6 is an imperative? As someone who in a former life worked inside large ISPs on the networking side I can tell you that that view would be quite rare. What would be the politics exactly?
Most ISPs run Juniper and Cisco gear in their core, both of these have have been capable of routing v6 for well over a decade now. Additionally if you are running older gear you would have hit the 512K route TCAM limit years ago.[1]
None of this would have anything to do with existing support contracts either. You would be pretty hard-pressed to find a rev of JunOS or IOS/NXOS that didn't support v6.
It's actually much more efficient to route v6 than v4. The global IPv4 table 719K prefixes now while IPv6 has 52K See:
http://www.cidr-report.org/as2.0/
and
http://www.cidr-report.org/v6/as2.0/
Lastly the fee schedule for IPv6 allocations from RIRs are not cost prohibitive for an ISP. Using ARIN as an example here:
https://www.arin.net/fees/fee_schedule.html
[1] https://blogs.cisco.com/sp/global-internet-routing-table-rea...