News for hackers. Stuff that matters.
Re:Prototype to production: How to build and design a PCB pr... by djthorpe on Wednesday March 07, 2018 @04:49AM (#16535325)
I suppose this is only the first article, but before you commit components to a manufactured board, I recommend you do a schematic layout and then a wire-wrapped or bread-boarded version first. Manufacturing takes time, and can be costly in mostly time if you make a mistake.

I made a few PCB's using http://aisler.net/ which seem fine for prototype manufacturing. They can also make the laser-cut stencil for SMD component mounting. You can upload Eagle BRD files directly (my experience with KiCAD and Fritzing was a lot less than stellar). Cost was around nine euros for three small PCB's and another nine for the stencil and took about a week to be delivered.

Re:Prototype to production: How to build and design a PCB pr... by pjc50 on Wednesday March 07, 2018 @07:23AM (#16535891)
This rather depends on what you're doing - anything which relies on controlled impedance or high-speed digital is a pain in wire-wrap and even more so on a breadboard. If you can stand the delay a PCB can be a cheap and reliable way of getting started. If you leave enough space that you can green-wire over PCB errors you can have the best of both worlds.
Re:Prototype to production: How to build and design a PCB pr... by antoniuschan99 on Wednesday March 07, 2018 @06:25AM (#16535708)
Is this the same as oshpark?
Re:Prototype to production: How to build and design a PCB pr... by djthorpe on Wednesday March 07, 2018 @06:39AM (#16535757)
OSHPark also allow you to upload Eagle BRD files, but based in the US. I think it's a separate company.