News for hackers. Stuff that matters.
Re:Aura: shipping software that was delayed for 4 years beca... by c2h5oh on Friday February 23, 2018 @08:16AM (#16446100)
Uncompressed stereo 16 bit 44.1khz sample rate (cd quality) is <150 KBps so it's definitely not bandwidth.
Re:Aura: shipping software that was delayed for 4 years beca... by makomk on Friday February 23, 2018 @08:36AM (#16446199)
It's bandwidth. More specifically, standard TOSLINK only has the bandwidth to carry stereo audio in uncompressed form. If you want full surround sound it needs to be compressed to fit into the same bandwidth that stereo audio would use.
Re:Aura: shipping software that was delayed for 4 years beca... by ComputerGuru on Friday February 23, 2018 @09:23AM (#16446437)
I thought the problem wasn’t toslink (the physical optical layer) but rather s/pdif (the software layer) which is constrained by its support for the rca physical layer?

IIRC, toslink 1.0 (circa ‘82 or ‘83) had a limit of 2 or 3 mbps while modern toslink is well over 100mbps (constrained more by distance than speed).

Re:Aura: shipping software that was delayed for 4 years beca... by DiabloD3 on Friday February 23, 2018 @10:34AM (#16446906)
SPDIF is not a software layer, but a limited version of AES3 for consumers. In the OSI model, AES3 would be considered layer 2.

Layer 2 is not considered software, although it can be performed by software in systems where such a concept makes sense. However, in AES3, this does not make sense, and has always been handled in devices via a chip that merely turns AES3 into I2S to be fed to either a DAC or another interface chip (ex: conversion between AES PHYs is often done by just bridging the receiver of one type to the transmitter of another type semi-blindly via I2S).

Also, the AES3 protocol is incredibly simple. It only has a very limited set of flags (very limited in today's sense, more than enough for what was intended in 1985, see https://en.wikipedia.org/wiki/AES3#Channel_status_word ), and was never actually meant to do anything but stereo audio at conventional rates. Doing encoded bitstreams across it is largely a hack, and is limited to the base versions of Dolby and DTS.

Using >3mbit over Toslink is not done involving an AES3-purposed PHY, but instead with other unrelated protocols, such as Digital ADAT. Distance on typical Toslink is already constrained to about 30 feet.

I have seen other people quote this mythical 100mbit number, but no one has ever been able to cite such a use in the real world: no standard I have ever seen that uses Toslink as a PHY has supported such a transmission rate: ADAT maxes out at around 12mbit, and MADI does not use Toslink at all.

Also, in further irony, in use, I have found unbalanced AES3 (such as via RCA or BNC) to be more reliable than Toslink; and virtually all of professional AES3 usage is done by 3 pin XLR because of how unreliable Toslink is...

Although a lot of professionals have moved on from AES3 entirely, and use MADI or Dante, or don't use digital transmission pipes inside of their studio at all and run it entirely on a single PC.

Re:Aura: shipping software that was delayed for 4 years beca... by ComputerGuru on Friday February 23, 2018 @10:10PM (#16451413)
Very interesting reply, thank you. I meant to say “protocol layer” rather than “software layer” but misspoke. The correction is appreciated.

I think I’m going to do some more research on that 100mbps number. Perhaps they meant Bd/s?

Re:Aura: shipping software that was delayed for 4 years beca... by ConnorBoyd on Friday February 23, 2018 @12:41PM (#16447878)
CD quality is 1.4 mbps

16 * 44,100 * 2 = 1,411,200

Re:Aura: shipping software that was delayed for 4 years beca... by c2h5oh on Wednesday February 28, 2018 @10:07AM (#16483431)
Lower case "b" - so bits. 1,411,200bps = 176,400Bps ~~ 172KBps I wasn't that far off.