Re:There's a Persistent Hum in Windsor, Ontario, and No One ...
by jjwiseman on Tuesday February 20, 2018 @08:37PM
(#16426096)
You could start with two mics going into the same computer. Even a few feet of separation might be sufficient. Plug them into a mixer, one as the left channel and the other as the right channel of a stereo stream to keep their samples synchronized. Filter, then cross correlate the signals to find the phase difference/TDOA.
[ Parent
| on HN ]
Re:There's a Persistent Hum in Windsor, Ontario, and No One ...
by blunte on Tuesday February 20, 2018 @09:59PM
(#16426480)
Since low frequency waves have a very long period, I don't think any mics near each other would give much useful location info. Depending on where a given mic was relative to the wave, I expect the recorded volume would be very different.
Re:There's a Persistent Hum in Windsor, Ontario, and No One ...
by jjwiseman on Tuesday February 20, 2018 @10:09PM
(#16426521)
Yeah, 20 Hz = 17 m wavelength, so move the microphones to be at least 17 meters apart, or a bit more if you think the sound is below 20 Hz, which should be doable.
And yes, I don't expect comparing amplitude to be useful--sound localization almost always uses TDOA/phase difference for that reason.