Only the very top end of multifamily rental housing is comparable in quality to ordinary single family homes. I have found high-rises to be more solid than mid-rises, probably because steel is a must.
You have to look at just how deeply our culture rejected cities and how deeply ingrained the American Dream of suburbia became.
One important thing: always ask for MgO board with MgSO4 binder. MgClOn ones can turn corrosive due to minute manufacturing procedure deviations.
Foamed concrete:
https://en.wikipedia.org/wiki/Foam_concrete
Made in two ways:
1. You mix polymer or protein foam into concrete.
2. You mix bubble generating chemical into concrete that will expand it after the pour.
It is a tricky and rather obscure tech mostly used across the former bloc countries or places that used to receive Soviet tech like India. Working with it is much more of a skill rather than science, and this hampers its adoption.
Biggest roadblocks other than skill intensity:
1. Corrosion protection - porous concrete is obviously more permeable than solid one. Easy ways to protect armature do not work as with solid concrete. Zinc anodized steel or other consumable protections will simply be consumed much earlier than in solid concrete, or worse, be eaten by lower PH of a foam concrete after settling. You have to put additional alkalinisers, or flyash, but they can destroy the foam. Finding a foam that will stand your alkaliniser, or a particular composition of flyash (flyash from different powerplants and blast furnaces can be dramatically different chemically and change in composition over time!) is always a challenge.
2. Faster hardening, especially with alkalinisers or geopolymer base - 40 MPa in just 2 days. You also have to spray formwork with water copiously to prevent it from premature drying.
3. Bigger sensitivity to chemical purity of components in general. Additives for foam concrete are an esoteric matter.
What I say about it: advantages worth the trouble
1. You can go down in density down to 350 per cube, or even 150 if you are a concrete chemistry magician. 350 gives you 0.1 W/mK thermal conductivity
2. Incomparably more flowable and pumpable.
3. You can use cements that are wholly geopolymer based or natural cements which is a huge economic incentive.
4. Can be used structurally above 600 per cube density with 13kg/cm2 load bearing capacity. Load bearing capacity goes up non-linearly. 850/cube already give you 30kg/cm2
5. Settled foam concrete is workable with just saws and hand tools. If you have to fix a screw up, it is much easier than with solid Portland cement.
6. Works like magic with stay-in-place formwork.
That is rather sophisticated by North American standards for multi-family housing.
I was stunned when I first saw multi-family houses being built in American as a simple wooden, skeletal structure.
My choice for something like that would've been steel frame with thermal stops for non-load bearing walls, non-removable formwork out of something like MGO board, and foam concrete pour. Not much separate insulation required for this design.