The Mars Curiosity rover among other probes use a thermocouple based generators to create electricity from the fission heat[1]. Extremely robust , no moving parts, but extremely inefficient just a few percent converted to electricity the rest to heat. The heat is very useful on mars though due to the low temps, kinda like your combustion engine in your car, the waste heat can be used to provide useful heating, but still most needs to be rejected and it only puts out about 100 watts of electricity.
This new one looks to be striling engine based which means its going to have much better efficiency since it is a more standard heat engine with moving parts, prob 20-40%. Hence the higher output. However that comes with much more complexity and things to go wrong over long term use.
I still wonder if there is much more efficiency to be had from thermocouple's if the research effort was put into it, it would be similar to solar cell improvements over the last few decades. You just don't hear about thermocouple R&D and if it where improved to say a typical solar cell efficiency of 18-20% it would open all sorts of doors.
1. https://en.wikipedia.org/wiki/Radioisotope_thermoelectric_ge...
"Thermonuclear" usually refers to the sorts of fusion reactions found in stars and modern nuclear warheads.
[1]: https://en.wikipedia.org/wiki/Radioisotope_thermoelectric_ge...
This reactor says it uses U-235 which would be full fission similar to the US SNAP-10A[2] or Russian BES-5 RTG[3]
So yes the fission part is more complicated than a P-238 alpha decay RTG. Perhaps I mischaracterized the R&D complexity on the reactor portion, although it has been done before.
1. https://physics.stackexchange.com/questions/35303/alpha-deca...
When writing the answer, I didn't even consider, that those reactors need to be fast reactors. In retrospect it is obvious, but makes controlling the power even harder.
The maximum what you can get can't be higher than the hypothetical ideal quantum diode made from a material pair.
There are much more down to earth alternatives that beat both stirlings and thermocouples on reliability and specific power density: thermionic converters, thermoaccoustic generators, AMTEC converters, radiophotovoltaic (works only in 0g)
"Thermoelectric efficiency depends on the figure of merit, ZT. There is no theoretical upper limit to ZT, and as ZT approaches infinity, the thermoelectric efficiency approaches the Carnot limit. However, no known thermoelectrics have a ZT>3."[1]
There seem to be some in promising materials with a ZT of 2.2[2] which is around 20% similar to a solar cell. It seems again if more R&D where applied we might be able to make that cheap and practical.
1. https://en.wikipedia.org/wiki/Thermoelectric_materials#Devic...
2. https://newatlas.com/most-efficient-thermoelectric-material/...
2. Quantum tunneling - electrons will tunnel back to lower charge density region, and preventing them from doing so is effectively impractical with modern day tech.
If they were any actual thermocouples with 20% efficiency, they would've nuked piston engines long time ago.
Simply putting the reactor together and testing it are more complicated than they seem. This is because of three things matter can reflect neutrons back, humans are harmed by radiation, and humans are the ones assembling/transporting/testing the reactor. We have to be careful putting the reactor together so that it doesn't spew neutrons and harm the humans assembling it. We need to develop ways to transport the reactor so that it doesn't spew neutrons. When we test the reactor, we have to set up our test so that humans won't have to get anywhere close to the reactor for a couple of months. There's also other issues like training people to do these things and NASA cooperating with the DOE to do the testing. These are 'simple' things, but they still need to be done.
Those probes are absolutely not using fission. Radioactive decay is not the same thing.
All of these tests involve fissile materials, so to quote Red Alert, "Gentlemen, it's a nuclear device."
[0]https://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/201700... [1]https://www.nasa.gov/sites/default/files/atoms/files/kilopow...
This isn't a fission test. It's a mechanical engineering test. Still cool.