It is similar with the choice of 3 phases for electrical power distribution, you can add more phases but it just adds to the cost with little benefit.
AC is used because it's very simple to step up to very high voltage for efficient long distance transmission and then back down to safer low voltages for use, while doing the same with DC requires significantly more complex electronics.
However, at very low frequencies you need to use very large transformers which cost a lot and look ugly, and at higher frequencies you lose efficiency due to skin effect [1].
50 Hz is a good compromise - transformers are of a practical size and skin depth is about 9 mm, which is larger than most conductors and therefore doesn't add much loss.
If you increase the frequency to just 10 kHz (which is still considered very low) the skin depth decreases to only 0.6 mm, and you would have significant loss on even moderate sized conductors.
Jeez, when it comes to electricity, it is just like peeling an onion with layers of ignorance...
[1] https://en.wikipedia.org/wiki/High-voltage_direct_current
My guess for the frequency, is that it is a harder conversion to perform with acceptable loss. Compatibility reasons doesn't allow for just bumping it up. Also let's not forget that AC frequency actually comes from the revolutions per second the power generator does, so there may be some other physical limiting factors here.
Last, some underground high power transmission lines are actually emerged into oil, to keep them cool.
I'm pretty sure that's the minimum to prevent perceptible light flicker.
His idea for ultra-efficient high-voltage, high-frequency AC power lines is a good example. It would probably work, but his proposed system required liquid insulation on the wires; it would be important to keep gases out of the medium, and the slightest break in a solid insulation like rubber or silicone (or gutta-percha) could basically turn the wire into the business end of a tesla coil.
So...I don't understand enough about the subject to say for sure, but we probably landed on 50-60Hz for a reason. I wonder why this one didn't wind up working out, but I'll bet it's described somewhere in the application which I've only skimmed.
Also, for anyone else trying to dive into it, 'condenser' = 'capacitor' in olde-speak.