One wacky thing in IBM's transistor computers is that they would alternate NPN and PNP gates. This avoided an extra transistor in each gate to shift the voltage level back. So you'd end up with one gate using +12V/0V logic levels and the next one using +6V/-6V.
This technique was used in three different transistor logic families, each with their own voltages. So there were 6 different transistor logic levels, plus other miscellaneous logic levels (e.g. 48V relays). IBM's old computers were a crazy collection of different voltage levels.
Huh? The gate resistance of a FET is hundreds of megaohms, so the input current is measured in nanoamps. That doesn't seem like high current to me.
This is different from current-steering based logic (all kinds of ECL, including CML/SCL) were the current in the circuit stays the same, but only takes a different path depending on state. Supply current is largely independent of circuit state with these.
Note that "high" and "low" here are quite different from the usual digital logic conventions of high=+V, low=GND; in this case, high would be near GND while low is a negative voltage. The circuit manual PDF gives low=-30 and high=+10. A lot of other early transistor logic families operated with such "unusual" (for today) signal levels too.
The other notable characteristic of tube circuits is the high resistor values --- this is because they operate at low current (in the mA range) but high voltage (hundreds of voltages). Contrast this with transistor logic which is relatively high current and low voltage.
One amusing component I found in the tube module was "Vitamin Q" capacitors.
Those are actually very desired by audiophiles, so it's odd to see them in a digital circuit. They're paper-in-oil capacitors and "Vitamin Q" was Sprague's trade name for the proprietary oil they used.