News for hackers. Stuff that matters.
Re:I amplified my home's Wi-Fi with aluminum foil by topspin on Tuesday December 26, 2017 @10:47PM (#16012687)
Done wrong this will increase reflected energy at the feed point and make the transceiver run hotter than it is supposed to, possibly leading to an early failure. Measuring SWR at 2.4/5 GHz requires some expensive instruments; note that the link you provided has only "calculated" SWR, not measured. Wifi doesn't involve much power, but these low cost Wifi transceivers are engineered with rather limited headroom for reflected energy and shipped with antennas that work within those limits, so if you do this you're a test pilot; there is no complaining if it lunches itself.
Re:I amplified my home's Wi-Fi with aluminum foil by arghwhat on Wednesday December 27, 2017 @02:29PM (#16017259)
As long as you're not running a high-power transceiver (i.e. not consumer gear or consumer gear out of legal spec), I would not be worrying about SWR problems. Consumer Wi-Fi chipsets are designed to be fairly rugged. They normally operate nowhere near their limits.