All but the most simplest embedded systems are complex enough to require some pre-developed library or abstraction layer to stand between a single tinkerer and the hardware. Otherwise it would take you an eternity just to stand up a "Hello World!" The cost of a Linux-capable SoC is low enough that you can buy one for $5 in the form of the Pi Zero. If a system complex enough to run Linux only costs $5 to sell, and probably even less to make, what incentive is there anymore to produce hardware that's simple enough to work with directly at the assembly layer?
The last holdouts are extremely power-efficient embedded systems. And even then you can do those with C.
I'm an old fart who can remember the "good ol' days" just as well, and I still program the SNES as a hobby. But really, that's all it'll ever be anymore; a hobby for legacy systems. There's no reason anymore to even skip C, when architectures have been so fine-tuned for code written with C.
For instance, in our case and the case I know best, we could use a full 32 bit ARM arch in our hardware but we do not; we retarget a very simple microcontroller with a few kilobytes of memory for this because it is far cheaper and far less power hungry. Result is that we have to use asm or C with quite a high % of asm. We decided to use only asm because it makes the audits easier too. Because of this work I got to meet many manufacturers and these components are in a lot of appliances and are often coded in asm.
It's definitely out of fashion, but when something complicated breaks, where is the "adult" you call to figure it out? :)
I do 100% agree that commercial systems / enterprise / game dev is past the low level era, but the knowledge of the area is anything but obsolete for the reason I mentioned before.
my hope was to try to stand these up on systems that i actually use on a day-to-day basis, so it's kinda disheartening that that may be overly ambitious, but i'll write about it if i have any success :)
So one of those platonic store instructions might actually be a no-op; you can't tell by looking at it in isolation.
Also, the "API"'s you have to learn are incredibly simple compared to learning API's for every framework and protocol in high-level programming. If devices are memory-mapped, than all I'll ever need to know is load and store. I just need to look at the registers that are available for each I/O device, what their addresses are, and what the bits represent in them. From there I access them all the same way: load and store. Couldn't possibly get any easier than just moving things around between registers and memory.
Compare that to high level development like web development, where you need an understanding of HTTP on top of one of infinite different web backends, written in different languages, all using different libraries with different naming conventions and different programming paradigms, plus knowledge of HTML, CSS, possibly another smorgasbord of frameworks, plus knowledge of decent security practices, databases, operations, and the list goes on.
It's obviously apples to oranges though, and I can produce a lot more real-world value doing web development than I can doing assembly programming, at least just as one person. My point is that I really like the simplicity and straightforwardness of writing assembly, at least in the few very short times I've done it. Maybe large assembly projects have all the same challenges as high-level development or worse.