Re:3D Printing High-Strength Aluminum
by aidenn0 on Saturday September 23, 2017 @01:40PM
(#15320783)
I wonder if there are novel shapes of bicycles that could be enabled by this; a triangle made out of tubes has a good strength-to-weight ratio, but perhaps it could be improved?
[ Parent
| on HN ]
Re:3D Printing High-Strength Aluminum
by hwillis on Saturday September 23, 2017 @02:17PM
(#15320942)
I doubt you could do anything to a bike frame with this that you couldn't with foam-core carbon fiber. The advantage 3d printing over CFRP is cost is constant with intricacy and number of joints. That means its best for skeletonizing to a small scale or lightening really intricate parts, and expensive for large, sweeping parts (like the shape of a frame).
So, you could skeletonize things like brake levers/mechanisms to a much higher degree than with older aluminum alloys. The ultimate limit to skeletonizing something is the tensile strength since each member basically becomes a wire eventually. At that point its strength is determined by the tension it can sustain rather than the bending force.