Re:SanDisk crams 400GB into a microSD card
by derefr on Saturday September 02, 2017 @08:11PM
(#15158977)
"SD" is basically the name of a standard stack, not a particular layer. You can reformat an SDHC card to not be FAT32, but then it won't be an SDHC card any more.
There is a point to this: SD cards are used in all sorts of low-level embedded applications, with firmware that uses very inflexible (usually assembler) code to address the card. The assumptions about the SD wire protocol + the FAT32 filesystem + even the particular location of the FAT table on disk are all knotted together in these devices.
Because of this, it's not even just that SDHC requires FAT32; SDHC requires FAT32 done with a specific formatting tool released by the SD standards group. Because your OS might put the FAT anywhere, but the tool puts it in exactly one place, and that's the place that dumb embedded devices expect to find it.
There is a point to this: SD cards are used in all sorts of low-level embedded applications, with firmware that uses very inflexible (usually assembler) code to address the card. The assumptions about the SD wire protocol + the FAT32 filesystem + even the particular location of the FAT table on disk are all knotted together in these devices.
Because of this, it's not even just that SDHC requires FAT32; SDHC requires FAT32 done with a specific formatting tool released by the SD standards group. Because your OS might put the FAT anywhere, but the tool puts it in exactly one place, and that's the place that dumb embedded devices expect to find it.