News for hackers. Stuff that matters.
Re:Can you figure out how this single part boost converter w... by kazinator on Friday June 09, 2017 @02:22AM (#14519514)
Re:Can you figure out how this single part boost converter w... by comboy on Friday June 09, 2017 @03:04AM (#14519638)
That was my first thought too, but he explains that in the last paragraph:

> I am also obsessed with eliminating hardware with clever software wherever possible. Hardware is mater and is therefore you have to manufacture, move, and dispose of each and every hardware part used. None of these these problems apply to software

Re:Can you figure out how this single part boost converter w... by buserror on Friday June 09, 2017 @06:23AM (#14520400)
I'm a big fan of joule thiefs. Small solar panel, a supercap and a joule thief and you can trickle charge NiNM batteries for years+. That's how I keep my hand-radios fully charged when not in use.
Re:Can you figure out how this single part boost converter w... by lightedman on Friday June 09, 2017 @12:22PM (#14522432)
Don't even need the supercap.

Resistor as the inductor, HW012 IC, hook up a solar cell, LED, and battery. Boosts 1.2V to 3.6V.

http://i.imgur.com/3y1PMoP.jpg

Re:Can you figure out how this single part boost converter w... by vortico on Friday June 09, 2017 @02:29AM (#14519535)
The limitation is that the GPIO pins have an overprotection diode, so you have you have to get around that somehow.
Re:Can you figure out how this single part boost converter w... by makomk on Friday June 09, 2017 @09:08AM (#14521054)
I don't think that you necessarily do. The protection diode just dumps voltage into the Vcc line of the microcontroller, which if you're clever may not necessarily be an issue.