Re:Electrick: Low-Cost Touch Sensing Using Electric Field To...
by joezydeco on Wednesday May 10, 2017 @01:49PM
(#14310088)
That's great detail, thanks for looking that up. The 200Khz wave may not be a big deal, but when you start getting strong harmonics then things really go south in your certification tests.
Once on a capacitive screen controller design I had to stick in some pseudo-randomization on the electrode PWM to avoid this coupling. It was a pain in the ass.
Re:Electrick: Low-Cost Touch Sensing Using Electric Field To...
by csoete on Wednesday May 10, 2017 @06:31PM
(#14312329)
Just for your information (I am not big fan of the product), but there are battery free (energy harvested) switches which can replace copper runs already.
See for example: https://www.enocean.com/en/enocean_modules_902mhz/
What worries me about this approach is the need for calibration. I don't see anywhere that indicates they've tested to see the effects of the wearing down of the topcoat and conductive spray layer upon the accuracy. It would be cool to be able to simplify a light switch installation to slap(electrodes)-spray-spray-calibrate, it would suck if I had to re-calibrate once every few years.
Now if we can figure out how to beam low-voltage, low-amperage power over building distances and through insulation, then we could remove a lot of copper runs. Beam just enough low power to drive and sense these kinds of control surfaces, and control relays sitting in front of the actual devices' electrical connections.
[1] https://transition.fcc.gov/oet/spectrum/table/fcctable.pdf