News for hackers. Stuff that matters.
Re:Printed Electronics (2016) by StavrosK on Tuesday May 09, 2017 @09:06AM (#14299626)
This isn't really that much different from etching your own PCB. You just print the circuit on a laser printer, stick it on a copper board, pour some etchant and that's about it.

Of course, you then have to solder the components, which is a time-consuming and difficult process, what with the size of electronics these days. Most components' pads are a fraction of a square millimeter.

EDIT: I may be misunderstanding your point, as the article talks about printed displays etc, but I don't see how you could just get an inkjet cartridge that would allow a home printer to create a display...

Re:Printed Electronics (2016) by xg15 on Tuesday May 09, 2017 @12:02PM (#14301136)
> [...] pour some etchant [...] solder the components

I think that's where the differences would start for most people. In the parent's vision, you could assemble complex PCBs using ordinary office supplies and with little knowledge except about the circuit you want to build.

Today, you'd at least need a dedicated hobbyists' level of space, tools, and knowledge how to use the tools safely.

Re:Printed Electronics (2016) by blacksmith_tb on Tuesday May 09, 2017 @03:44PM (#14303219)
Unless your printer was just spitting out downloaded circuits, I am skeptical that you'd reach the masses. Already the Arduino et al. has helped to let people make electronics via more software and less hardware, and even that doesn't mean that there's one in every home.
Re:Printed Electronics (2016) by devrandomguy on Tuesday May 09, 2017 @01:40PM (#14302208)
This Thinfilm company claims to be able print basic displays already, and hints that the process involves 5 layers of material. I'm guessing that there are two outer conductive layers, of longitudinal and lateral electrode arrays respectively. Two of the inner layers would form the P-N junction of an OLED.

Not sure what that fifth layer would be, though. It could be something as mundane as a non-stretchable structural support. Or, it could be that there is more to OLEDs than the Wikipedia article lets on.

https://en.wikipedia.org/wiki/OLED#Polymer_light-emitting_di...

As for how this would be printed, that is probably just a matter of coaxing the required layer-chemicals into a suspension that has the right consistency for their own printers. I recall an article a while ago, about some pharmaceutical researchers teaming up with HP to develop chemical print heads that spit out protein solutions, and then spit drugs onto them, in order to rapidly test millions of different concentrations. These people might even be using that same printer.