Re:Getting Closer to Mass Production of Bones, Organs, and I...
by jessriedel on Friday April 28, 2017 @01:13PM
(#14221218)
Could you say more about it? For typical holes left by neurosurgical procedures the 3D printing part may be useful for comfort or cosmetics, but I think it is unlikely to be critically important. Surgeons have been using simple metal plates to patch holes in the skull for many decades, and they work pretty well.
[ Parent
| on HN ]
Re:Getting Closer to Mass Production of Bones, Organs, and I...
by Tharkun on Friday April 28, 2017 @02:36PM
(#14221908)
Part of her skull was damaged when she was a child. At the time it was replaced by some kind of plastic. But from what I gather it slowly started to deteriorate, until it got infected and pressure built up and it had to be removed/replaced.
From what I can gather it's a piece a little over 10cm in diameter and resides above her ear.
Re:Getting Closer to Mass Production of Bones, Organs, and I...
by blazespin on Friday April 28, 2017 @03:22PM
(#14222287)
Metal Plates make MRIs a pain.
Re:Getting Closer to Mass Production of Bones, Organs, and I...
by jessriedel on Friday April 28, 2017 @05:52PM
(#14223399)
No, essentially all modern metal implants are non magnetic, e.g., titanium. They go through MRIs all the time.
Re:Getting Closer to Mass Production of Bones, Organs, and I...
by mattkrause on Friday April 28, 2017 @07:41PM
(#14224074)
No, it's still a pain.
Titanium is MR-compatible: the magnet won't rip the plate out of your head, which is good. However, it can cause huge artifacts that obscure things around the titanium implant (and, sometimes, depending on the scan parameters and implant location, elsewhere too).
This is particularly annoying because the implants are often right near the areas you really want to image....
Re:Getting Closer to Mass Production of Bones, Organs, and I...
by pinot on Friday April 28, 2017 @01:34PM
(#14221390)
Just based on what they have on their site, no simple metal plate could make the shapes that they do/are working on.
http://www.materialise.com/en/medical/patient-specific-impla...