See the blue line in the graph here: https://www.advancedpilot.com/redbox.html
or the CHT line on the graph in Lycoming's (in)famous "Experts are Everywhere" document: http://users.kymp.net/kotkanik/documents/SSP700A.pdf (note that in the Lycoming document, leaner mixtures are on the left and in the APS red box graph, leaner mixtures are on the right; Lycoming graphs BSFC and APS graphs 1/BSFC)
> But, in general, leaner is hotter, not cooler.
That is not borne out by the data shown in graphical form in the links above (which agree with each other and match my experience operating big-bore Continental engines).
Only while richer than 25 rich of peak EGT is your statement correct. Lean of peak, leaner is in fact cooler, which was my original claim.
> Also, peak cylinder pressures are higher when run RoP.
From a cylinder longevity standpoint, this is a bad thing, of course. It's particularly a bad thing when cylinders are run very hot (over say 425F) because aluminum loses a significant percentage of its strength in that temperature regime: https://www.nap.edu/openbook/NX006900/xhtml/images/p20003245...
On a Cessna 182 I used to run, I could lean it to 50-52 litres per hour, using a digital fuel flow gauge (not standard factory equipment). If I leaned to 48 litres per hour, the EGT gauges clearly showed a rise in temperature for certain cylinders.
If I was leaning without using these gauges for assistance, it would be very easy to make a mistake and overdo it, or not lean enough and waste fuel/money.
But, in general, leaner is hotter, not cooler. At a ROP setting, the extra fuel that is not burned lands on many of the top end components including the exhaust valve. As it evaporates off the surface or out of the fuel/air charge, it cools the component or charge.
Also, peak cylinder pressures are higher when run RoP.
http://www.gami.com/paulferraris_leanofpeaksaga.pdf
In any case, the Cessna 172S Lycoming IO-360-L2A (engine) handbook says, "Continuous operation at mixture settings lean of peak EGT is prohibited"