News for hackers. Stuff that matters.
Re:Resources for electronic engineers and hobbyists by Animats on Wednesday February 01, 2017 @03:56PM (#13545069)
It's not about getting it hot enough.

Surface mount soldering requires a careful temperature profile. You first preheat to about 50C below the melting point of solder for about two minutes. Then, the temperature is raised to above the reflow point and held there for about 20 seconds, which is when the soldering takes place. It's easy to damage the components at this point; many components have a maximum temperature tolerance of only 30 seconds at reflow temperature.[1] Then there's a cool-down period. There are ramp rate limitations - heating up too fast causes solvent "pops" in the flux, and heating up too slowly cooks the components. Cooling too fast causes cracks in the solder; cooling too slowly cooks the components. A brick kiln would have too much thermal mass for all those controlled temperature changes.

Once it's all tuned and controlled properly, it works great as a cheap production process. The commercial systems work like a hamburger cooker at Burger King - there's a chain conveyor and several zones of different temperature through which the product passes. Once one of those ovens is warmed up and stabilized, it produces consistent results. It's doing this on one-offs that's hard.

Leaded soldering is about 2x more tolerant of temperature variations than lead-free.

[1] http://www.latticesemi.com/~/media/LatticeSemi/Documents/App...

There are no comments on this comment yet.