News for hackers. Stuff that matters.
Re:Build a Custom-Printed Circuit Board by hga on Tuesday May 04, 2010 @09:15PM (#1319996)
Cool! MOSIS (http://en.wikipedia.org/wiki/MOSIS) for PCBs.

Although I remember fabricating a couple in the '70s by hand, although not hardly as fancy or with such fine details (you lay out your pattern on the board with stickers and/or a pen of the right sort and then bathe it in an etching solution that removes the copper that's not covered).

I think some people are also doing 2 layer boards using milling machines to remove the copper.

Re:Build a Custom-Printed Circuit Board by _mattb on Tuesday May 04, 2010 @09:31PM (#1320033)
Yeah, you can still do pretty well nowadays with photo-etching pre-sensitized boards. Here's Abe Lincoln (and a legitimate circuit) I did a while back: http://i.imgur.com/PyLyn.jpg

And PCB isolation routing! I've tried it with broken drill bits as mills and the Eagle to G-code software. It worked ok but I couldn't figure out DIY solder masks.