News for hackers. Stuff that matters.
Re:Slack client for Commodore 64 by a1k0n on Tuesday November 29, 2016 @01:42PM (#13065176)
FWIW you probably don't need a USB serial port, or a RS232 converter at all; you could just pick the TTL serial signals off the commodore port and plug them into the TTL serial port on the Raspberry Pi 23- or 40-pin expansion slot (pins 8, 9, and 10 are TX, ground, and RX.). Remove the tty on /dev/ttyAMA0 from the init config and you can use /dev/ttyAMA0 as your built-in Pi serial port.
Re:Slack client for Commodore 64 by khedoros1 on Tuesday November 29, 2016 @04:21PM (#13066376)
The DC voltage supply on the Commodore side looks like 5V, and at a guess, the TTL probably runs at that voltage too. The Pi won't be happy with more than 3.3V on its UART pins, so the USB adapter also fills the purpose of a voltage adapter.
Re:Slack client for Commodore 64 by a1k0n on Tuesday November 29, 2016 @10:20PM (#13068233)
Right. I thought it might be 5v tolerant on the RX pin but maybe not.. easy enough to just use a resistor and a diode to the 3.3v supply to level shift there, and the 3.3v TX should be fine for a 5v logic input.
Re:Slack client for Commodore 64 by jeff_harris on Tuesday November 29, 2016 @01:48PM (#13065227)
Thanks, yeah, I will try this - I followed a design for a c64-pc cable without considering that the Pi probably had serial port pins.