[edit]
ISDN is a catch-all term tat included BRI (2 B channels) and T-1 (24 B channels) and E-1 (30 B channels) so the parent comment is correct.
* ISDN BRI = two 64k B channels and one 16k D channel
* ISDN PRI over T1 = twenty three 64K B channels and one 64k D channel
* ISDN PRI over E1 = thirty 64k B channels and one 64k D channel (time slot 0 on the E1 was used as a sync channel and wasn't considered a B or D)
T1/E1 was considered an analog circuit with 24 or 32 respective 64kbps voice channels using in band signaling effectively limiting each channel to 56k. ISDN PRI used the same cabling and channel separation, but instead ran a digital circuit with out of band signaling enabling the full 64k to be available for voice and data. ISDN PRI (and BRI) also allowed the option to be packet based (similar to X.25) rather than circuit switched for data transmission.
A typical configuration would terminate the analogue lines over ISDN, which supported somewhere up to 30 B channels ('voice calls') over a single cable, running alongside one or two Ethernet cables to a single router with one or more modem option cards installed.
We had Cisco boxes in the last place I worked that handled dialup, looking pretty much like this: http://www.ciscomax.com/datasheets/3600/Cisco_3640.jpg