Moller was trying to build a VTOL powered by Wankel engines. His company was trying to build Wankels with much better power to weight ratios than usual. As usual, this resulted in much reduced engine lifespan. (Classic tradeoff, as everybody in drag racing knows.) He's been able to build a vehicle that can get off the ground, and hover a bit, tethered from a crane, for 2-3 minutes.
Pure-thrust VTOL is quite possible with jet engines. The aircraft that do it, such as the Harrier and the F-35, are fighters, which are mostly engine anyway. It can be done, but not at low cost or high payload or high efficiency.
Jet engines remain expensive. Despite many attempts, small, cheap, reliable jet engines remain out of reach. Below 6-passenger bizjet size, reliable engines don't seem to get much cheaper. There are cheap high-powered small jet engines with model aircraft levels of reliability and a life of 100 hours or so. That's how the Flyboard Air does it.[2] Not being stupid, they always fly this over water at low altitudes.
[1] http://www.downside.com/scams/moller/ [2] https://www.youtube.com/watch?v=KEDrMriKsFM
50+ years and $100m in R&D no viable prototypes might have something to do with it.
Maybe the approach was doomed from the start, but that didn't stop Moller from promising that you would be commuting to work by air in 10 years for decade after decade.
tell this to fusion guys :)
>no viable prototypes
i find this for example as looking very viable back at the time
https://www.youtube.com/watch?v=3MwxVAZuFOs
and actually if you add more props (possible with electric today not so much with gas engines back then) and much-much better control electronics you'll get the modern multi-copters :
volocopter prototype https://youtu.be/L75ESD9PBOw?t=97 and pre-production https://youtu.be/VAEy0NltoFQ?t=78
>Maybe the approach was doomed from the start, but that didn't stop Moller from promising that you would be commuting to work by air in 10 years for decade after decade.
only the last one, m400 was doomed as i mentioned above (and it wasn't actually that clear from the start, m400 was actually pretty logical and reasonable move forward - only after first tests one could see it clear). Put yourself at his place at any point in the history of his flying car development and those 10 years would look like a reasonable estimate. I personally actually say today that in 5 years we'll have the Volocopter likes flying around.
> tell this to fusion guys :)
Drop the "50+ years" and tell it to every other SV startup these days... ;).
Plus, they would spend most of the time in the shop anyway. Moller's big idea was to design an engine that was cheap, lightweight, had a very high power to weight ratio, efficient, and extremely reliable. For some reason he has had trouble making an engine that ticks all of the boxes.
i wonder why such animosity toward Moller. His approach on the last incarnation of the car has some technical mistakes which made it a dead end, yet looking into his history and the overall history of VTOL i wonder how people may see that as a scam. It is pretty obvious today that we will have human carrying 8/12/16-copters in the next few years (we actually already have them as actually flying prototypes today) and that is pretty much where Moller was in 198x-199x just adjusting for the non-availability of modern hardware and electronics back then (so he went for complicated double-engine-same-shaft design with minimum of controlling electronics - the approach which doomed the last incarnation. I do fail to see a scam here.)