News for hackers. Stuff that matters.
Re:Implication of sabotage adds intrigue to SpaceX investiga... by R_haterade on Saturday October 01, 2016 @12:13PM (#12618466)
Steel-core 7.62x54 would probably do it well enough. And you can buy that by the case, cheap.

All you would really have to do is get fuel dripping out along the surface to a point where it would ignite from heat from the engine exhaust.

Re:Implication of sabotage adds intrigue to SpaceX investiga... by wbl on Saturday October 01, 2016 @03:07PM (#12619386)
Not even. LOX is explosive when it contacts organic matter like wiring harnesses, plus Dewars are very fragile, and breaking the vacuum would result in a lot of boil off.
Re:Implication of sabotage adds intrigue to SpaceX investiga... by R_haterade on Saturday October 01, 2016 @03:30PM (#12619494)
I did not know this. So it's even easier than I thought to sabotage a rocket launch.

Thanks for replying--I would have gone to my grave not even considering the fact that rocket fuel has oxidizers mixed in, but the search you just sent me on set me straight.

Re:Implication of sabotage adds intrigue to SpaceX investiga... by jakub_h on Saturday October 01, 2016 @06:31PM (#12620180)
It's not mixed-in, it's in a separate tank. But since the tank is an aluminum alloy (often with copper or lithium mixed in) these days, I wonder about its behavior in the presence of an ignition source (some magnesium in the bullet or perhaps even just friction?).
Re:Implication of sabotage adds intrigue to SpaceX investiga... by jakub_h on Saturday October 01, 2016 @06:26PM (#12620159)
There's no Dewar vessel on the LV as far as I'm aware of. The surface of the stage is the propellant tank, made of simple Al-Li alloy, several millimeters thick. It works fine because of the large mass of the LOX and the comparatively short time of the stage's operation. You just can't transfer enough heat into the stage naturally in the short twenty or thirty minutes between fueling and launch to cause any trouble.

Before they started supercooling the LOX, it was even easier because heat transfer into LOX tanks is conventionally managed by boil-off (in launchers without supercooled propellants, latent heat keeps the liquid at a stable temperature and a trickle refills the tank continuously until a minute or two before launch).