The heating does not come from friction. If a gas is compressed, it heats up. Moving through air compresses it in front. There's a point on the leading edge where the air is actually still. That's the point of maximum compression, and maximum heat (and minimum friction!). (Pitot tubes work on this principle, they are simply air pressure gauges calibrated to read as speed rather than PSI.)
This misattribution is one of my pet peeves. <grump>
Interesting. The SR-71 Blackbird was dark (almost black) in order to radiate heat efficiently [1]. Then again, the Blackbird flew much higher (at around 26 km compared to Concorde's just over 18 km) so maybe convection plays a bigger part in Concorde's thermal management.
[1] https://en.wikipedia.org/wiki/Lockheed_SR-71_Blackbird (Although my primary source is the book "Skunk Works" by Ben R. Ritch and Leo Janos.)
Concordes were specced with Anti-flash White (high reflectivity as used by US and UK nuclear bombers), and the main reason I remember is there was some publicity when France painted one Pepsi blue (not wings) for a sponsorship. It had to have speed restrictions.
Wikipedia has a little more (not much), but says the white finish reduced the skin temperature by 6 to 11 degrees Celsius.
Since radiant (photons) heat emission follows radiant heat absorption: Black absorbs better, but also emits it better.
Maybe they didn't care about emitting heat, they just didn't want the sun adding heat?
The SR-71 Blackbird was black because that color dissipates heat. [1] The plane was also made from titanium, not aluminum so there may be other factors but black dissipates heat as well as it absorbs it.
[1] http://www.lockheedmartin.com/us/100years/stories/blackbird....
edit: they say that farther down the page
"...and a radar-absorbing element was added to the paint."
Wouldn't the color only matter when it comes to heating due to absorption of electromagnetic radiation?
For heat transfer by direct contact with the heat source (in this case gases that were heated when compressed by the plane's motion), wouldn't color be irrelevant?
That's the other benefit of electric planes.
Supersonic aircraft fly at higher altitudes in general - the Concorde cruised at 56000 feet.
If there's air there's friction, if there's no air there's no thrust. Rockets take their own oxidant.
Like the intense friction, and heating, supersonic flight produces. Concorde's service speed was limited by heat limits place on the aluminium alloy to ensure a decent service life. They were always white as that was part of the spec - dark colours would have taken heat absorption out of limit!
Wing roots varied by >100C each flight if I remember right, and fuel was used as a heat sink. Are we going to use the batteries?
If the outer surfaces are conductors, what are we doing about icing conditions?
Concorde, or likely most SST, engines put out a lot of thrust in a very fighter-like profile (they were a continuation of a fighter engine, and had reheat). Electric fans aren't going to work efficiently in that profile and would probably be large diameter, which isn't very supersonic friendly.
How are we now handling taxiing and subsonic? Edit: To expand the last point, Concordes were horribly inefficient subsonic, and burnt something like 2t of fuel to get to the runway. Reheat was used at takeoff and going transonic. They pumped tonnes of fuel after reaching supersonic - for weight and balance and reduced drag. They were basically really big fighters.