Re:FarmBot – Open-Source CNC Farming [video]
by hutzlibu on Thursday June 09, 2016 @07:26AM
(#11868669)
> It seemed to me like you weren't familiar with the concept
And you seem to me, like you were not familiar with the topic being discussed:
output of the same amount of land, no matter the required work (because of robots)
So, nevermind ;)
Re:FarmBot – Open-Source CNC Farming [video]
by HeyLaughingBoy on Friday June 10, 2016 @04:18PM
(#11879663)
The problem isn't the potential output of the land; it's that the costs go up rapidly. With a very large field a traditional tractor/plow/disk/seeder/cultivator can do a lot of work in a short amount of time. If the field is now 1/100 the size, the "tractor" (robot, etc.) and its implements don't cost 1/100 as much. They may only cost 1/5 as much, so your costs are now 20x what they would otherwise have been for the proportional output.
I think that's the point he was trying to make.
In this case, each microfarm will produce less vegetables than a macrofarm of the same size.
I wasn't trying to be a jerk by linking to the Wikipedia article. It seemed to me like you weren't familiar with the concept.