FPGA tools have been so bad for so long that I just don't think there's enough executive bandwidth to truly embrace software. The economics of being an FPGA designer pretty much requires lockin. It is a lot to ask of a team.
Yeah, so ASICs that are not produced in big enough volume will not move to 14nm or less. This means that FPGA that can move to 14nm or less, because of bigger volume, may become competitive against those ASICs.
Will xilinx create industrial FPGA's at 14nm or beyond ?
First transistor cost will have to become meaningfully lower than 28nm transistor costs. That only happens at 10nm. But at that node, NRE costs are extremely expensive. Spread over low-cost low-end industrial chips - this requires a huge volume, which xilinx probably doesn't have yet.
Also couple that with 28nm being more much reliable(all the failure mechanisms increase at 10nm: electron migration from wires, thermal hot sports, transistor fin self heating), and since reliability is key for industrial - it would be hard to see industrial moving beyond 28nm.
But what if
a. xilinx built c-like tools that enabled embedded software engineers develop easily ?
b. they released those freely to some segment of the market ?
c. they've built an external support and IP ecosystem, either open or closed or both ?
Those actions can increase margins for xilinx, and they seem to be doing a,b.
As for the hardware, maybe the article is right. Also ,recent industrial chips are using 28nm, and going beyond that is extremely expensive and might not fit the industrial scenario anyhow, maybe there's not a lot of innovation left in the industrial FPGA market,