News for hackers. Stuff that matters.
Re:Hoverboard Teardown by Animats on Monday April 11, 2016 @04:06PM (#11474680)
No mention of the battery pack or charger, the most troublesome components.

The in-wheel motors are kind of neat. Those could be useful for motion control projects, especially since they're three-phase synchronous and can be run all the way down to zero speed with high torque. More info about the power drive system for the motors would be useful. What are they using to switch all that current? No heat sinks are visible, so either the switching is really efficient or the drive electronics will overheat.

It's good to see precision motor control at this price point. These devices are rather impressive technically. Once somebody starts shipping them with safe batteries and full battery protection circuitry, they could be popular again. Boosted brand electric skateboards got it right; they used a safer battery chemistry, figuring the boards would be abused. Good call.

Most recent major hoverboard fire: Orlando, FL, 3 days ago. 3 apartments destroyed.

Re:Hoverboard Teardown by kens on Monday April 11, 2016 @04:19PM (#11474759)
If you're interested in a hoverboard battery pack and motor drive, take a look at the hoverboard teardown that I did with iFixit: https://ifixit.org/blog/7821/swagway-teardown-hoverboards/
Re:Hoverboard Teardown by Animats on Monday April 11, 2016 @05:00PM (#11475060)
That's a more useful article. Thanks.

The three motor lead colors not matching is amusing. Those are three-phase motors; any connection will work, but half of them will make the motor go backwards. Swapping any two leads will reverse the motor. I wonder if, with the colors correct, one motor is in reverse.

Re:Hoverboard Teardown by shabble on Monday April 11, 2016 @05:02PM (#11475069)
> What are they using to switch all that current? No heat sinks are visible, so either the switching is really efficient or the drive electronics will overheat.

My guess, pretty well verified by some similar pics in teh teardown by kens in a sibling comment, is that the "the main PCBA was located. There were fourteen screws and washers holding down the board, which was probably done to reduce vibration on the critical components."

is probably the mosfets attached to the backing panel for heat-sinking, rather than specifically for rigidity.

If you look at one of hte middle images[1] you can see what looks like imprints of thermal paste around each of the mounting holes.

[1] https://daks2k3a4ib2z.cloudfront.net/5654e7207deb65b23ea76b7...

Re:Hoverboard Teardown by fictivmade on Monday April 11, 2016 @05:54PM (#11475445)
That is indeed thermal paste and there was an aluminum backing acting as a heat sink under the PCBA.