News for hackers. Stuff that matters.
Re:How I Made a Cheap PCB by cillian64 on Thursday March 31, 2016 @09:00AM (#11396787)
What do you cut your stencils from? I've spent a lot of time mucking about with various plastics and never gotten particularly good results - 0.5mm pitch pads tend to start melting together into a mess. The good stuff is meant to be Mylar, AKA PET. I've bought plastic advertised as Mylar which has not been particularly good, and I suspect it may actually be PE rather than PET, as apparently the two are often confused.
Re:How I Made a Cheap PCB by jwr on Thursday March 31, 2016 @09:17AM (#11396901)
Just order them from OSHstencils. They aren't expensive.
Re:How I Made a Cheap PCB by ZenoArrow on Thursday March 31, 2016 @09:59AM (#11397187)
Depends on how much you want to spend. If you're on a tight budget, you could try this...

http://www.popsci.com/article/diy/build-diy-soldering-stenci...