One attack vector is stealing cars out of a supermarket parking lot. You just wait for someone to drive up in the model car of your choice and have your accomplice discreetly follow them into the store. When your accomplice texts you that they are at the bread aisle/back of the store you can just steal with impunity knowing that a bystander will see no difference between the actual owner who has the key in his pocket and you with your relay device in your pocket. You also know that your victim is in the back of the store and that they can't get within sight of you before you're already long gone.
>A PKES car key uses an LF RFID tag that provides short range communication (within 1-2 m in active and a few centimeters in passive mode) and a fully-fledged UHF transceiver for longer range communication (within 10 to 100 m). The LF channel is used to detect if the key fob is within regions Inside and Outside of the car. Figure 2(b) shows the areas in proximity of the car that must be detected in order to allow a safe and convenient use of the PKES system. The regions are as follows. [1]
1. http://www.syssec.ethz.ch/content/dam/ethz/special-interest/...
Yes, the actual key itself is located by the car based on Low Frequency RFID.
The attack described is a relay attack, which means that the key can be spoofed in real time by relaying short range radio transmissions to two locations.
The mistaken assumption of the security system is that the short range communication protocol used by the car and the key requires the key to be in close proximity to the car.
Since the communication may be relayed, the range assumption is invalid. The main suggestion is to use high precision timing to determine the range, as it is very difficult to cheat on the speed of light.
I agree that "signal strength" is not the best way to phrase the above in a technical discussion.
I have not seen any indication that triangulation or any other physical location system is used in vehicle PKES.
The only way to secure against the described exploit is to measure round-trip-time from the car -> key -> car and ensure it's under, say 5 light-meters: aka 16 nanoseconds, plus the carefully calibrated time it takes the key to compute its response.
16 nanos is a very short amount of time, and it'll be tricky to measure that reasonably accurately.
The real solution is to require the user to interact with the key in some way, like pressing a button, or perhaps moving it around (as would happen as you walked with it in your pocket).