You also have to pull up CH_PD and pull down GPIO15, plus usually include a voltage regulator and/or smoothing cap, which adds enough hassle that WeMos is definitely worthwhile, but it's not really that bad if you only have the bare modules.
The WeMos is infinitely easier, especially because it has the FTDI chip built in, but it's not terrible to use the bare modules. I got on the ESP8266 bandwagon fairly early, so I got used to working with the bare modules since they were all I could get.
[1] https://www.adafruit.com/products/2471
[2] https://home-assistant.io/blog/2015/10/11/measure-temperature-with-esp8266-and-report-to-mqtt/The ESProto 1 is designed to support the AI Thinker ESP-12F (FCC Certified) module, and give you space for an optional regulator, and prototyping space on board. We include jumpers and a push button for easily entering programming mode.
The ESProto IoT is our newest prototyping board, and couples the ESP-12F with a 5v Arduino Pro Mini to provide enhanced connectivity for sensors and peripherals, all in the form factor of the Arduino Uno.
Both boards use external USB for programming.
These things are too cool, and too much fun!
In the mean time, the Github repo is at: https://github.com/Wovyn
We've got the initial KiCAD files up there, and are putting together our sample code, etc.
More info at: http://github.com/hallard/WeMos-shield
The bare chip won't be very useful to you, unless you want to design your own PCB. Instead, I would recommend a breakout board. There are two major types:
Something like the WeMos D1 Mini (http://www.aliexpress.com/item/D1-mini-Mini-NodeMcu-4M-bytes...) or NodeMCU (http://www.ebay.com/itm/NodeMCU-LUA-WIFI-Internet-Developmen...), which are very full-featured and include onboard USB programmers and fancy things like that, but are a bit bulky. The NodeMCU I linked is solid, the WeMos is also great as it's much smaller and only includes the useful pins.
The alternative is a bare breakout board, which is the minimum that you need to make the ESP breadboard-friendly and so you don't have to solder a bunch of resistors on the chip. This is best when you want to work at a lower level, and have the minimum hardware required for the ESP to work on the board, with everything else going in your circuit.
There are breakout boards on ebay like this one (http://www.ebay.com/itm/1Set-ESP8266-WiFi-Module-Breakout-Bo...). STAY AWAY FROM THESE. They don't include all the necessary components, so the ESP won't work reliably without extra pullups, and they take up the entire breadboard space.
Because I was burnt by these, I designed my own and made it open-source:
https://github.com/skorokithakis/tiny-ESP8266-breakout
It's easier to work with, leaves room on the breadboard and includes all necessary resistors/caps and an optional voltage regulator. It's also very small. There's a dirtypcbs link on the github repo so you can just order 40 of these for $14 if you like, or you can just download the KiCad schematics (KiCad is awesome and open-source) and get it fabricated at your favorite PCB house.
Back to our regularly scheduled programming. Feel free to copy/paste this comment whenever there's an ESP discussion, I think it's a good primer for people who don't have ESP experience.