Especially for a general audience, but even people familiar with log scales, it doesn't give an intuitive feel of the actual numbers.
I am lamenting that they are not, because for many, many purposes they are easier to read and facilitate more useful intra-chart comparisons than linear-scaled charts. In particular, they make the slope of lines meaningful in many cases where linear-scaled charts do not. They also fit much more useful information about relative magnitude and allow us to read a couple significant digits of numbers across a wide range of scales. Any time there is more than 2 orders of magnitude difference among values a chart, a linear scale becomes nearly useless.
Reading charts at all is an acquired skill, and takes a lot more practice than you might expect. Just like doing arithmetic with fractions, decimals, or angles of a circle is an acquired skill, or driving a car is an acquired skill. If you study young children or people from non-literate cultures, you’ll see all kinds of difficulty reading linear-scaled charts.
Edit: here, I spent a couple minutes making a linear-scaled and a log-scaled chart of the wikipedia $/gigaflops table from elsewhere in this thread, using Matlab. See how much useful information you can get from the linear-scaled chart:
http://i.imgur.com/A80Tr6V.png http://i.imgur.com/xG0mngX.png
(On the log-scaled chart, if we penciled in a grid, you could get at least one significant figure out of each data point, despite the data spanning 11 orders of magnitude. On the linear-scaled chart, you get 2 significant figures for a single data point, but there’s no way to make any distinction at all between the rest of the values, which span about 8 orders of magnitude.)
The video used a zooming chart, which solves both problems.
Sure it does. The number goes from 10^12 down to 10^-1, 13 orders of magnitude. You can easily read these off the side or count the number of grid lines crossed. (Whoops, I wrote 11 in my comment before.) If you’re used to reading a log-scaled chart, counting the powers of ten along the vertical axis is perfectly “intuitive”, or at any rate just as “intuitive” as any other way you could write these.
In distance scale terms, this is the same as going from nanometers to tens of kilometers. Or in time scale terms from milliseconds to hundreds of years.
Numbers with such a big difference in scale are to some extent inherently incomparable: We don’t interact with such a range of scale with most of our naked senses, but need tools to understand and compare such divergent numbers. (Though if you’re hunting for an analogy, comparing volume or mass might be slightly easier, as they scale with length cubed. 13 orders of magnitude gets you from the mass of a human egg cell up to the mass of a tank.)
It’s in some ways too bad that slide rules have been replaced by electronic calculators. I feel like the general public coming out of high school used to have more fluency with logarithms, which until the last generation or two were the basic tool for all calculation in science and engineering.
Trying to study rates of growth on a linear scale is basically impossible during exponential-ish growth periods. All but the rightmost end of the chart gets squished flat along the horizontal axis.
Similarly, charts of e.g. currency exchange rates, stock indices, comparative economic growth between countries, etc. should most of the time be plotted with a log-scaled vertical axis. Otherwise there’s no way to accurately compare slopes in different parts of the chart, which can be deeply misleading.