Personally, I use a "Maxxwave 1106" running BSD I had laying around but it's on the more expensive side. If I was putting something together for myself, I'd get one of the small Atom boards with a couple of onboard Intel NICs.
It's a little bit more complicated to get running since it requires a custom compiled OpenWRT, but it's great to have more memory and disk space than I'll ever need in my router. I used to run on OpenWRT on reflashed consumer routers and I always had to be real careful about what I installed and ran. With the APU I can just install real `bash` and `less` and not have to deal with the crappy busybox emulations.
http://www.firewallhardware.it/en/alix_pfsense_embedded.html
I use a standard BananaPi as NAS and are very satisfied with it. It comes with a SATA interface and 1Gb ethernet.
My preferred pfSense platform at both home and the office is a server-grade chassis running ESXi. My router runs in a VM on this server and I use vSwitches to connect the VM to the various ports on the 4-port Intel NIC.
I just built it like this for convenience (I already had the ESXi server) but I later found a side-benefit: if you've set up a DMZ on pfSense, you can easily attach VMs to the DMZ by associating them with the DMZ vSwitch. So, I have some untrusted VMs sitting in my DMZ and trusted VMs sitting on my LAN...all on the same piece of hardware.
I've been running this way since 2013 and it's been flawless and fast. More details here:
http://output.chrissnell.com/post/39550480075/the-jack-of-al...