Re:On choosing the Z80 over the 6502 (2014)
by userbinator on Sunday December 20, 2015 @12:01PM
(#10767520)
Hot air is definitely the right way to do it for SMD/BGA, and I find it much easier than through-hole because you don't have to solder each pin separately -- just aim the gun at the part and wait for the solder to melt. The surface tension means the part will actually self-align into place over the pads if you get it close enough.
BGA is not that much more difficult; look online for videos of the phone repair shops in China which can swap BGA chips in literally minutes.
BGA is not that much more difficult; look online for videos of the phone repair shops in China which can swap BGA chips in literally minutes.