Re:A 3-D printer capable of incorporating hydraulics
by fyrejuggler on Sunday December 20, 2015 @03:15PM
(#10768144)
Feels like 3D Printers are making progress like mad lately.
I think it's time to get my hands on one. I will just make myself an xmas present and get a little machine to get going. Currently undecided between getting a small Printrbot for about $400 or a larger Maker Farm for about $600:
after a modest amount of research and as a complete beginner, I've been very happy with the purchase. Prints PLA, ABS, HIPS (and probably nylon though I haven't cracked open the spool of nylon I bought yet).
Re:A 3-D printer capable of incorporating hydraulics
by Frenchgeek on Sunday December 20, 2015 @06:10PM
(#10768698)
Well, I own a printrbot simple maker's edition ( the plywood one, in short ) and one small lesson I've learned with it is this :
Go for a printer with a heated print bed : It will save you many headaches.
Without heated bed : Check if the masking tape still is good enough for a print, if not, remove it and add a few new layers, prep the tape with some glue ( Only way I get something to stick ) and let it dry a little. Then you can attempt a print.
With a heated bed : clean up the glass plate, add some polyvinyl hairspray and you're good to go!
Re:A 3-D printer capable of incorporating hydraulics
by mcbutterbunz on Monday December 21, 2015 @01:23AM
(#10769887)
I'll second this about the heated bed. I have the Printrbot Play and I like it but I wish it had a heated bed. I have overcome most adhesion issues by printing larger brims on small prints. Then I have to cut off the brim. This wastes filament and adds another step to the process.
Re:A 3-D printer capable of incorporating hydraulics
by lunchTime42 on Monday December 21, 2015 @05:59AM
(#10770554)
its fascinating though how few coments this topic recives.
HW_ComentDensity= Personal.usefullnessOfTopic(topic) / RangeOfSkillsNeededForDuplication* DepthOfArticle
I think it's time to get my hands on one. I will just make myself an xmas present and get a little machine to get going. Currently undecided between getting a small Printrbot for about $400 or a larger Maker Farm for about $600:
http://www.productchart.com/3d_printers/7001_vs_5881
Any suggestions for a complete beginner are welcome.
after a modest amount of research and as a complete beginner, I've been very happy with the purchase. Prints PLA, ABS, HIPS (and probably nylon though I haven't cracked open the spool of nylon I bought yet).
Do yourself a favor and print one of these: http://www.thingiverse.com/thing:23257
and buy one of these: http://www.harborfreight.com/1-inch-travel-machinists-dial-i...
That will help you level the bed as a beginner. (It gets a little easier with practice, but having numeric references helps.)
While at HF, buy http://www.harborfreight.com/pack-of-3-8-oz-storage-bottles-... as well. That will come in handy when getting ABS prints to stick (one will hold the acetone slurry, one will hold pure acetone and you have one left over)
Go for a printer with a heated print bed : It will save you many headaches.
Without heated bed : Check if the masking tape still is good enough for a print, if not, remove it and add a few new layers, prep the tape with some glue ( Only way I get something to stick ) and let it dry a little. Then you can attempt a print.
With a heated bed : clean up the glass plate, add some polyvinyl hairspray and you're good to go!