News for hackers. Stuff that matters.
Re:Nintendo Controller Teardown by 6502nerdface on Thursday November 19, 2015 @04:19PM (#10597762)
Yes! Also goes by part number 74LS165 (edit: actually they are just similar) [1]. Here's how to use it in your game code: http://wiki.nesdev.com/w/index.php/Standard_controller

Basically you write high voltage to the "strobe" line of the shift register in the controller, putting it in a state where it continuously updates to reflect current button presses. Once you remove the high voltage, it "freezes" its 8-bit state representing whatever combination of the eight buttons were last depressed, and then you make 8 successive reads from the shift register's serial line, reading off the state 1 bit at a time. It's up to the game software to be robust against bouncing, as well as against a tricky hardware bug where the DMC module of the NES's audio processing unit conflicts with the latching mechanism used by the controller's serial line. Needless to say, this must all be emulated by accurate NES emulators, too :)

[1] http://www.datasheetcatalog.com/info_redirect/datasheet/phil...

Re:Nintendo Controller Teardown by cnvogel on Thursday November 19, 2015 @04:52PM (#10597986)
Look closely, the '165 is a little different, both in functionality and pinout. You'll not be able to swap in one for the other. -- But yes, both are parallel in, serial in/out shift registers.

http://www.nxp.com/documents/data_sheet/HEF4021B.pdf http://www.nxp.com/documents/data_sheet/74HC_HCT165.pdf (pinout for LS is the same)

Re:Nintendo Controller Teardown by duskwuff on Thursday November 19, 2015 @04:55PM (#10597999)
The 4021 and 74LS165 are similar, inasmuch as they're both PISO shift registers, but they're not the same part. Here's representative datasheets for both parts from TI:

http://www.ti.com/lit/ds/symlink/cd4021b.pdf

http://www.ti.com/lit/ds/symlink/sn74ls165a.pdf

I don't think the differences are relevant in this application, though.

Re:Nintendo Controller Teardown by kh_hk on Thursday November 19, 2015 @04:26PM (#10597806)
Maybe relevant, a while ago wrote a post about using an Arduino to interface a NES gamepad as HID device.

http://eskerda.com/arduino-nes-gamepad/

Repo with full instructions: https://github.com/eskerda/arduines

Re:Nintendo Controller Teardown by mrob on Thursday November 19, 2015 @09:58PM (#10599309)
Bouncing isn't an issue if you poll the button state once a frame, because almost all switches will finish bouncing within 16ms.