News for hackers. Stuff that matters.
Re:Experts Still Think UBeam’s Through-The-Air Charging Tech... by raverbashing on Thursday November 12, 2015 @08:31AM (#10552980)
Even the cheapest digital voltmeters have 1MOhm input impedance

The one the parent mentioned has 10kOhm/Volt sensitivity, so for 10V range it gives 100kOhms

http://support.radioshack.com/support_meters/doc73/73794.pdf

Re:Experts Still Think UBeam’s Through-The-Air Charging Tech... by jacquesm on Thursday November 12, 2015 @08:37AM (#10553014)
Yes, but even cheap digital voltmeters (this one is analog) would not work well for high frequencies and does not measure power, a volt meter is simply the wrong tool for the job.
Re:Experts Still Think UBeam’s Through-The-Air Charging Tech... by raverbashing on Thursday November 12, 2015 @08:45AM (#10553058)
> would not work well for high frequencies

Correct, but it is going to measure something (it most likely rectifies and sends it to the meter, should work fine in the 100khz range)

> a volt meter is simply the wrong tool for the job

I don't disagree with this

Re:Experts Still Think UBeam’s Through-The-Air Charging Tech... by jacquesm on Thursday November 12, 2015 @08:52AM (#10553089)
It very much depends on the guts of the meter what it will indicate. "Something" is not a very scientific measure :)

The biggest factor are the ways in which the sample is taken and what kind of algorithm (if any...) is used to determine RMS. Simple meters simply rectify the AC current, add a small capacitor and a resistor to drain it and measure the DC voltage across the resistor. More advanced meters will use an isolation stage with a pre-amp driven from the auto ranger that will present the wave-form in one piece and suitably scaled to a DA stage where the sampling will take place. This allows for pretty good determination of the actual voltage (which in the case of AC has been agreed upon as root-mean-square, whereas, if the circuitry is bunk could easily become 'peak' or even 'nonsense').

Anyway, we're all in violent agreement that this measurement is bogus and since that is all the quantitative info there is I'll let it go here.

Re:Experts Still Think UBeam’s Through-The-Air Charging Tech... by cnvogel on Thursday November 12, 2015 @09:43AM (#10553367)
No need to digitize. There are analog multiplier and squaring circuits.

http://www.analog.com/en/products/linear-products/rms-to-dc-...