I guess you can also see it from conservation of momentum. Gravity acts on the plane, so each second there is a certain amount of downwards momentum added to the system. But the plane is not in fact moving downwards, so the all the downwards momentum has to end up in the air, so it has to move downwards. The net "lift" force is equal to the rate at which momentum is added to air.
If I understand it correctly, you can calculate the lift on the wing either in terms of the pressure on the two sides, or in terms of the downwards acceleration of air--it should be two equivalent views giving the same result. Bernoulli's principle gives a way to calculate the pressures if you only know the velocity of the air (this is a typical situation in a wind tunnel, where you make movies of moving smoke puffs), but it's not a separate effect from the air motion.
The compression of the air below the wing moves it downwards, more or less. There are no ways to get around Newton's laws of motion (barring relativity, and planes aren't fast enough for that).
Anyway, I'm not saying you're wrong, I'm just saying that thinking about the individual forces involved leads to more complexity than necessary (this is usually the case). It's much simpler to just consider the energy going into the system and derive the net work produced from that.
Then, there would be no lift generated, since there is no acceleration of mass.
For example, from Newton one can state that the whole lifting force F_lp acting on the plane is opposite to gravity force F_gp acting on the plane, so plane flies horizontally (in the simple case): F_lp + F_gp = 0. Next, from third law of mechanics the lifting force F_lp acting on the plane is opposite to F_da force acting on air downward: F_lp = -F_da. From the second law of mechanics force F_da acting on air causes the air momentum to change: F_da = dp/dt, which means that either the plane pushes a lot of air down or the plain pushes air down really fast, just like article says.
Looking into the picture from Bernoulli perspective, we can talk about flows around the wing. If say we have a wing which is flat underneath and curvy on top, the air is initially pushed upwards until the top point of the wing is reached. From there air continues along the wing profile, which goes down, so air has a chance to accelerate - this is effectively an empty space which becomes available to the air, and air goes from points of higher pressure to points of lower pressure. The air speed increases, the pressure remains less than in (unchanged) air below, so we're getting the Bernoulli effect - lower pressure above the wing.
If the plane is upside down, it won't fly horizontally. It has to fly somewhat upwards - in which case flows on both sides of wings change, with net effect the same - the air is pushed down, pressure under the wing is higher than above, both Newton and Bernoulli explanations work.
But, as everyone else responding to the parent has pointed out, the forces generated in this way are not nearly enough to keep the plane in the air on their own.