It seems like the real value of the picture was that it made it obvious how insecure the system was.
The tiny locks and keys kind of make it obvious that it's not so much insecure as it was never ment to be secure.
Can you reverse engineer a master key from one sample lock though? Genuine question, IDK.
Should be doable as long as you have the non-master key for that lock too. A standard key lock works by having pins which are separated into two pieces. The key lines up the boundaries with the cylinder, which allows the cylinder to turn. Master key systems are typically done by having the pins be separated into three pieces, which allows two positions to turn the cylinder. One position is used by the normal key, and one is used by the master key. Having the normal key will let you figure out which is which, and then you can figure out the master key from that.
The way I understand master keys work is that the lock has two "breaks" in each pin, instead of just one. So each pin has two positions that allow the lock to open, and you don't know which one belongs to the master key.
I think at least two locks would be required, and depending on how many pins and possible positions there are, more might be needed in case of a collision.
Re:TSA Master Keys
by brianwawok on Tuesday September 08, 2015 @11:53AM
(#10186415)
I mean a lock comes with 1 key right? If you make a second key that opens it, but shares nothing with the default key - you may have a winner.
Source needed.
Re:TSA Master Keys
by andyjohnson0 on Tuesday September 08, 2015 @10:30AM
(#10185872)
Make a working key from scrap metal by reverse engineering a lock
http://www.instructables.com/id/Make-a-working-key-from-scra...
Re:TSA Master Keys
by boredinballard on Tuesday September 08, 2015 @12:07PM
(#10186521)
If anything, this just made it easier for casual lazy people to get a set of images for keys they'll never make :)