News for hackers. Stuff that matters.
Re:Why We're Giving Away Free Robots by rmyers on Friday August 28, 2015 @08:12PM (#10138463)
Hi! Co-founder here...

KATIA plugs into a normal wall jack (120/240v single-phase), so you don't need to be wired for 360v three-phase power like you would with other industrial robots.

We also don't use any steppers or hobby servos like you would find on a toy arm. When we say the performance of an industrial arm, we mean it. We've built highly integrated, custom permanent magnet synchronous motors with 14-bit absolute rotary position sensors built into each joint.

Furthermore, the arm has been designed from the ground up for zero-backlash operation, and the rigidity is insane -- we're gettting less than one hundreth of a millimeter of transient deflection during our worst-case stress testing.

And it is made out of carbon fiber, because that's just how we roll.

Re:Why We're Giving Away Free Robots by pravda on Saturday August 29, 2015 @12:30AM (#10139068)
Well, I am very impressed.

14 bit = 2^14 = 16384. Optical or some kind of hall-effect? I am going to guess hall-effect.

When I read "permanent magnet synchronous motor" I think stepper-ish motor. Is that what the joints are? No gearbox, custom stepper-ish motor, with the 14-bit encoder giving feedback not just on the position, but also the load?

What voltage do these custom motors run on? I will guess .... 48V.

It is a very sleek-looking arm.

Re:Why We're Giving Away Free Robots by sbierwagen on Monday August 31, 2015 @10:55AM (#10147070)

  the 14-bit encoder giving feedback not just on the 
  position, but also the load?
Rotary encoder probably wouldn't give you that. Usually you just measure how much current the motor's drawing.