Re:With $100M in Funding, Carbon3D Will Make 3D Manufacturin...
by Retric on Thursday August 20, 2015 @05:11PM
(#10094696)
tens or even hundreds of thousands of cycles
If it's reasonably cheap to print, then only lasting say 2,000 cycles would not prevent a useful mid-scale production runs. Also, the high end of 3d printing is a lot tougher and has tighter tolerances than you might think.
http://www.gizmag.com/ge-fires-up-all-3d-printed-jet-einge/3...
Edit: after Reading the comment below, I admit I may be somewhat biased from working with more complex and detailed parts with very right tolerances, so there may be some applications where it is feasible. All the molds I've seen/worked with were made the old fashioned way.