News for hackers. Stuff that matters.
Re:With $100M in Funding, Carbon3D Will Make 3D Manufacturin... by Veedrac on Thursday August 20, 2015 @03:32PM (#10094091)
I don't know what the test case is, but going from the article[1], at 100µm layers it prints at 500 mm/hour.

Form 1+ claims 10 to 30 mm/hour at this resolution, so Carbon3D is 20-50 times the speed. That puts Form 1+ about 2-3 times as good as the graph suggests.

CLIP (Carbon3D's name for their tech) isn't layer-rate limited, but cure-rate limited so the comparison isn't quite fair.

[1] http://www.sciencemag.org/content/347/6228/1349.abstract (free access if you sign up for an account)

There are no comments on this comment yet.