thrownawayfan
Re:The fanless heatsink: Silent, dust-immune, and almost ready for pri...
on Monday June 25, 2012 @03:05PM (#4158111)
Wouldn't the boundary layer thickness be affected by the centrifugal force that presses the air against the fins? I was under the impression that that was the main advantage of this design.
Re:The fanless heatsink: Silent, dust-immune, and almost ready for pri...
on Monday June 25, 2012 @01:04PM (#4157404)
Of course, fitting this into a laptop would be problematic as well.
Re:The fanless heatsink: Silent, dust-immune, and almost ready for pri...
on Monday June 25, 2012 @01:03PM (#4157397)
According to them, the air gap provides a thermal resistance on the order of 0.02 C/W. The primary resistance is the fin -> ambient air interface.
This device is also very quiet, based on that video. Assuming their goal of 0.05 C/W resistance is reached, it would perform significantly better than the heatsink you're mentioning.
Re:The fanless heatsink: Silent, dust-immune, and almost ready for pri...
on Monday June 25, 2012 @12:04PM (#4157119)
There's a whitepaper available here http://prod.sandia.gov/techlib/access-control.cgi/2010/10025...
Their data suggests that the air gap provides minimal resistance to the flow of heat. As for the clearance, they've stated that unusually high-precision manufacturing is not required for the two surfaces.
Re:The fanless heatsink: Silent, dust-immune, and almost ready for pri...
on Monday June 25, 2012 @12:01PM (#4157104)
From the slides at https://ip.sandia.gov/techpdfs/Sandia%20Cooler%20presentatio...
>Q: Can the device be mounted in any orientation?
>A: Yes—the air bearing assembly is held together by magnetic attraction (between the stator and permanent-magnet rotor).